Radiator PCB test benchBoard v5 · test firmware bench-1

Not connected
This browser can't talk to USB serial devices. Open this page in Chrome or Edge on a desktop or laptop computer.

Board

Name
MAC
–
Chip
–
Flash
–
Firmware
–
Last reset
–
Uptime
–
Chip temp
–

Checklist –

Relay

–

Listen for the click and watch the red LED. With a meter on continuity, EL L to the TCO terminal beside it should beep only while the relay is on. The relay drops out by itself if this page stops talking to the board for 6 seconds.

ESP module

Blue LED

BOOT button: – (press BOOT on the ESP module to test it)

Sensors on J2 –

#Your labelTemperatureLast 20 sSensor addressStatus
No board connected.

To tell probes apart, pinch one between your fingers: its row is highlighted while it warms up. Labels are saved per sensor in the bench database.

WiFi reception

Not scanned

Checks the ESP's radio and antenna. Signal is in dBm: closer to zero is stronger; below about −75 is weak.

Boards tested –

NameMACResultSensorsLast tested
One row per board, with its checklist results and sensor addresses.
Raw messages from the board